Another card from my series of cards using the Classic Garage Suite.
This time the card has been stepped up again with lots of extra little bits added for the stamper who likes to do just a little more than creating a simple stamped card.
The base card is Crushed Curry and I have used a couple of pieces of the Classic Garage Designer Series Paper. The red piece I have torn and sponged with black around the edges.
The car has been stamped in Real Red on a piece of Whisper White cardstock and whilst the ink was still wet I used a Blender Pen to move a little of the red ink onto the car. This piece was then die cut and sponged with Basic Gray ink.
The sentiment has been been stamped in Black Memento Ink and trimmed to a small banner.
A piece of the Black Silver 1/4" ribbon has been adhered underneath the red piece of DSP.
The full cog die was used to cut out the cogs from Basic Black cardstock and was adhered flat on top of the red DSP.
The car and sentiment pieces have both been adhered with dimensionals and the Classic Garage Metal Element (Key) has been adhered flat to the left of the sentiment.
The edges of the whole piece has been sponged with Basic Gray ink and then adhered flat to the base card.
If you would like to create a card like this then these are the supplies I used. Don't forget you can order any of these products through my online store and you will have them shipped directly to you.
No comments:
Post a Comment